Acopia Networks ARX 6000 Manual de usuario descargar pdf (Pagina 10)

GUI Quick Start: Network

Setting Up Network Parameters

1-8 GUI Quick Start: Network Setup

Configuring IP Interfaces

The next screen configures the IP addresses for the ARX. All of these addresses must

be on a common subnet over the VLAN you specified in the previous screen:

In-band management IP address is a management address that is accessible

through the client/server VLAN configured above. Future connections to the GUI

can come through this in-band management interface, from a client or server

subnet instead of a separate management network.

Proxy IP addresses are used by the ARX to communicate with the file servers.

The correct number of proxy-IP addresses varies from platform to platform;

follow the on-screen instructions to add the correct number of addresses. These

addresses must be on the client/server VLAN configured above, and all back-end

file servers must be on the same subnet or reachable through the

Default Gateway

(below).

Subnet mask is the IP-subnet mask for all of the IP addresses on this screen.

Default gateway identifies the local IP gateway that the ARX should use to reach

all subnets outside the local proxy-IP subnet. Any clients or servers outside the

proxy-IP subnet must be reachable through this gateway/router.

For example, this ARX has an in-band management address at 192.168.25.5, uses 6

proxy-IP addresses, and has a default gateway at 192.168.25.1:

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

Acopia Networks ARX 6000 Manual de usuario Pagina 10