Acopia Networks 810-0044-00 Manual de instalación descargar pdf (Pagina 168)

100

101

Adding a Direct Volume

Adding a Share

8-12 CLI Storage-Management Guide

Using a Managed Volume as a Filer

You can assign a managed volume to the share as though it were an external filer.

(The next chapter describes how to configure a managed volume.)

From gbl-ns-vol-shr mode, use the

managed-volume command to use a managed

volume as a direct share’s “filer:”

managed-volume namespace volume [access-list list-name]

where:

namespace (1-30 characters) is the name of the namespace.

volume (1-1024 characters) is the volume’s path (for example, ‘/rcrds’). You

cannot use a direct volume; only a managed volume.

list-name (optional, 1-64 characters) is the NFS access list to associate with

the share (see “Listing All NFS Access Lists” on page 4-10).

For example, the following command sequence assigns the ‘wwmed~/it’ managed

volume to the ‘test’ share.

bstnA6k(gbl)# namespace medco

bstnA6k(gbl-ns[medco])# volume /vol

bstnA6k(gbl-ns-vol[medco~/vol])# share test

bstnA6k(gbl-ns-vol-shr[medco~/vol~test])# managed-volume wwmed /it

bstnA6k(gbl-ns-vol-shr[medco~/vol~test])# ...

Disconnecting from the Managed Volume

Use the no form of the command to stop using a managed volume as a direct share’s

filer.

no managed-volume

If the direct volume’s namespace supports CIFS, you can only use a managed volume

from the same namespace.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 491 492

Comentarios a estos manuales

Sin comentarios

Acopia Networks 810-0044-00 Manual de instalación Pagina 168

Comentarios a estos manuales