Acopia Networks 810-0044-00 Manual de instalación descargar pdf (Pagina 411)

100

101

Grouping Files into Filesets

Intersecting Filesets

CLI Storage-Management Guide 13-23

Identifying a Source Fileset

The final step in configuring an intersection fileset is to identify two or more source

filesets. You can include as many source filesets as desired, but you must have at least

two for the intersection to be meaningful. From gbl-ns-vol-fs-isect mode, use the

from

fileset

command to include a source fileset:

from fileset fileset-name

where fileset-name identifies the source fileset.

For example, the following command set intersects two source filesets to make the

“paidBills” fileset:

bstnA6k(gbl)# policy-intersection-fileset paidBills

bstnA6k(gbl-ns-vol-fs-isect[paidBills])# from fileset webdavPaid

bstnA6k(gbl-ns-vol-fs-isect[paidBills])# from fileset wdValid

bstnA6k(gbl-ns-vol-fs-isect[paidBills])# ...

Removing a Source Fileset

Use the no form of the from fileset command to remove a fileset from the list of

sources:

no from fileset fileset-name

where fileset-name identifies the fileset to remove.

You cannot remove the last source fileset if the intersection fileset is in use (that is,

referenced by another fileset or used in a rule). The next chapter has configuration

instructions for referencing a fileset from a rule.

For example, the following command set removes two source filesets from the

“paidBills” fileset:

bstnA6k(gbl)# policy-intersection-fileset paidBills

bstnA6k(gbl-ns-vol-fs-isect[paidBills])# no from fileset webdavUnderwritten

bstnA6k(gbl-ns-vol-fs-isect[paidBills])# no from fileset monthlyPaid group 2

bstnA6k(gbl-ns-vol-fs-isect[paidBills])# ...

1 2 ... 406 407 408 409 410 411 412 413 414 415 416 ... 491 492

Comentarios a estos manuales

Sin comentarios

Acopia Networks 810-0044-00 Manual de instalación Pagina 411

Comentarios a estos manuales