Acopia Networks 810-0044-00 Manual de instalación descargar pdf (Pagina 410)

100

101

Grouping Files into Filesets

Intersecting Filesets

13-22 CLI Storage-Management Guide

Removing the Fileset

Removing a fileset affects the switch configuration only; it does not delete any files.

Use

no policy-union-fileset to remove a union fileset from the current volume:

no policy-union-fileset name

where name (1-64 characters) identifies the fileset to be removed.

You cannot remove a fileset that is referenced by another fileset or used in a rule. The

next chapter has configuration instructions for referencing a fileset from a rule.

For example, the following command sequence removes the “allCustomerSide”

fileset:

bstnA6k(gbl)# no policy-union-fileset allCustomerSide

bstnA6k(gbl)# ...

Intersecting Filesets

You can intersect two or more filesets into an intersection fileset. An intersection

fileset contains files that are common to all of its source filesets; a file must be in all

of the source filesets to be included in the intersection. From gbl mode, use the

policy-intersection-fileset command to create an intersection fileset:

policy-intersection-fileset name

where name (1-64 characters) is a required name that you assign to the fileset.

As with any fileset, the CLI prompts for confirmation before creating a new

intersection fileset; enter yes to continue. This puts you into gbl-ns-vol-fs-isect mode,

where you identify two or more source filesets to intersect.

For example, the following command sequence creates an empty intersection fileset

in the “/acct” volume:

bstnA6k(gbl)# policy-intersection-fileset paidBills

This will create a new policy object.

Create object 'paidBills'? [yes/no] yes

bstnA6k(gbl-ns-vol-fs-isect[paidBills])# ...

1 2 ... 405 406 407 408 409 410 411 412 413 414 415 ... 491 492

Comentarios a estos manuales

Sin comentarios

Acopia Networks 810-0044-00 Manual de instalación Pagina 410

Comentarios a estos manuales