Acopia Networks 810-0044-00 Manual de instalación descargar pdf (Pagina 28)

100

101

Introduction

Getting Started

1-8 CLI Storage-Management Guide

bstnA6k(gbl-ns[wwmed])# enable

bstnA6k(gbl-ns[wwmed])# ...

Getting Started

For the initial login, refer to the instructions for booting and configuring the switch in

the appropriate Hardware Installation Guide.

For subsequent logins, use the following steps to log into the Acopia CLI:

1. If you are on-site, you can connect a serial line to the serial console port. This

port is labeled ‘Console;’ you can find it on the front panel of the switch. By

default, the port is set for 9600 baud, 8, N, 1.

You can also telnet to the switch’s management interface. For example:

telnet 10.10.10.10

In either case, a login prompt appears:

Username:

2. Enter your username and password. For example:

Username: admin

Password: acopia

The CLI prompt appears:

SWITCH>

The name, “SWITCH,” is the default hostname. The hostname is reset as part of

the initial-boot process, so it is likely that yours will differ.

Entering Cfg or Gbl Mode

The CLI contains two major configuration modes: cfg and gbl. The cfg mode contains

submodes for configuring locally-scoped parameters, only applicable to the local

ARX. These parameters include layer-2, layer-3, and chassis configuration. Gbl mode

applies to configuration that is shared among both switches in a redundant pair, such

as namespaces and global servers.

After you log into the CLI, use the

config command to enter cfg mode:

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 491 492

Comentarios a estos manuales

Sin comentarios

Acopia Networks 810-0044-00 Manual de instalación Pagina 28

Comentarios a estos manuales