Acopia Networks 810-0044-00 Manual de instalación descargar pdf (Pagina 402)

100

101

Grouping Files into Filesets

Grouping Files by Age

13-14 CLI Storage-Management Guide

For example, the following command sequence creates a new simple-age fileset:

bstnA6k(gbl)# policy-simple-age-fileset dayOld

This will create a new policy object.

Create object 'dayOld'? [yes/no] yes

bstnA6k(gbl-ns-vol-fs-simple-age[dayOld])# ...

Selecting Files Based on their Ages

The next step in configuring a simple-age fileset is to determine the age for its files.

The simple-age fileset defines a single age group for its files: older-than or

newer-than a certain time interval. From gbl-ns-vol-fs-simple-age mode, use the

select-files command to identify the age group for the files:

select-files {older-than | newer-than} count {minutes | hours | days |

weeks | months | quarters | years}

where

older-than | newer-than is a required choice.

count (1-4,294,967,295), and

minutes | ... years establish the time frame (for example, 15 minutes, 2

weeks, or 1 quarter).

You can run this command twice in the same fileset to choose files between two ages.

For example, you can

select-files older-than 2 months and select-files newer-than 3

months

to get a set of files between 2 and 3 months old. You cannot run a select-files

command that contradicts a previous one; if you already ran

select-files newer-than 1

week

, you cannot run select-files older-than 2 quarters.

For example, the following command set selects files for the “dayOld” fileset:

bstnA6k(gbl)# policy-simple-age-fileset dayOld

bstnA6k(gbl-ns-vol-fs-simple-age[dayOld])# select-files older-than 1 days

bstnA6k(gbl-ns-vol-fs-simple-age[dayOld])# ...

1 2 ... 397 398 399 400 401 402 403 404 405 406 407 ... 491 492

Comentarios a estos manuales

Sin comentarios

Acopia Networks 810-0044-00 Manual de instalación Pagina 402

Comentarios a estos manuales