Acopia Networks 810-0044-00 Manual de instalación descargar pdf (Pagina 88)

100

101

Preparing for NFS Authentication

Adding an NFS Access List

4-10 CLI Storage-Management Guide

The ARX supports up to 512 NFS access lists. From gbl mode, use the nfs-access-list

command to create a new one:

nfs-access-list list-name

where list-name (1-64 characters) is a name you choose for the access list.

The CLI prompts for confirmation before creating the new NFS access list. Enter yes

to proceed. This places you in gbl-nfs-acl mode, from which you can configure

various permit and deny rules for specific subnets and/or NIS netgroups. By default,

all subnets and netgroups are denied any access.

For example, the following command sequence creates a new NFS access list:

bstnA6k(gbl)# nfs-access-list eastcoast

This will create a new NFS ACL.

Create NFS ACL ''eastcoast''? [yes/no] yes

bstnA6k(gbl-nfs-acl[eastcoast])# ...

Listing All NFS Access Lists

To verify that your NFS access list was added to the configuration, use the show

nfs-access-list

command. You can invoke this command from any mode.

show nfs-access-list

The output shows all configured access lists in a table, one access list per row. For

each access list, high-level details are shown. These details are clarified in the

sections below.

For example:

bstnA6k(gbl)# show nfs-access-list

Access List Name Anon UID Anon GID Num Rules Num References

----------------------------------------------------------------------

eastcoast 100 100 8 2

westcoast 65534 65534 2 0

bstnA6k(gbl)# ...

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 491 492

Comentarios a estos manuales

Sin comentarios

Acopia Networks 810-0044-00 Manual de instalación Pagina 88

Comentarios a estos manuales