Acopia Networks 810-0044-00 Manual de instalación descargar pdf (Pagina 237)

100

101

Adding a Managed Volume

Adding a Share

CLI Storage-Management Guide 9-43

The following changes were made to replicate nested shares and their

attributes to the new share:

Added share “CELEBS$” to the following filer:

Filer Name: fs1

IP Address: 192.168.25.20

Path: d:\exports\histories\VIP_wing

Added share “Y2004” to the following filer:

Filer Name: fs1

IP Address: 192.168.25.20

Path: d:\exports\histories\2004

Added share “Y2005” to the following filer:

Filer Name: fs1

IP Address: 192.168.25.20

Path: d:\exports\histories\2005

**** Total processed: 3

**** Elapsed time: 00:00:03

**** Share Enable Filer-Subshare Inconsistency Report: DONE at Wed Dec 20 14:46:53 2006

****

bstnA6k(gbl-ns-vol-shr[medarcv~/rcrds~charts])# ...

This sample report shows that the volume successfully replicated three subshares.

Later, all three subshares can be exported from a front-end CIFS service.

For a volume that supports filer subshares but does not replicate them, the report

would have shown which subshares and ACLs were discovered on the filer. All

subshares must match in terms of their directory paths (relative to the share root),

share names, and ACLs. If a subshare definition is inconsistent at the share, this report

describes the inconsistency. The inconsistent subshare is unusable by the managed

volume. You can access the filer directly to make the subshare/ACL consistent. Then

you can use the priv-exec

sync shares command to add the subshare(s) into the

managed volume. For details on the

sync shares command, see “Adding and

Synchronizing Filer Subshares (CIFS)” on page 5-30 of the CLI Maintenance Guide.

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 491 492

Comentarios a estos manuales

Sin comentarios

Acopia Networks 810-0044-00 Manual de instalación Pagina 237

Comentarios a estos manuales